Application-Specific Tube & Pipe Bending Tooling
Every tube and pipe bending application presents its own mechanical and material challenges. Wall thickness, centerline radius, alloy composition, mac...
660 End Finishing Machine
The 660 enables operators of all experience levels to accurately finish up to 1,875 ends an hour. It allows you to free up lathes or other expensive machines on a wide range of work, such as simultaneous inside-outside deburring, chamfering, and facing. It can also increase production and improve accuracy over abrasive belts, deburring wheels, or other similar methods.
Capable of tubing range from 7/16" to 2" diameter
Manually lever operated or optional air operated
Many customization options are available
Technical Data
Configuration
- The Pines Model 660 End Finishing Machine is built to stock with the following standard equipment:
- Capable of tubing range from 7/16” to 2” diameter
- Manually lever operated
- ¾ HP motor
- Finish up to 1500 ends per hour
- Power: 115V/1 phase /3 Hz
- Air operated – Increased production by 25% – 30%
- Standard tool holder seats three bites for inside-outside deburring, chamfering and facing.
- Special tool holder – no tool bits – covers work for 1/8” min OD through 5/8” max OD
- Standard tool bits – fits standard tool heads. Size from 7/16” min to 2” max
- Tool setting gauge
- Vertical mounting base
- Coolant unit
- 1 HP Modification – Motor has 560 – 1250 RPM range
- Round tubing, 7/16” to 2” with standard tool holder
- Round tubing, 1/16” to 5/8” with special tool holder
- Finish up to 1500 ends per hour
- Deburr and chamfer inside, outside and face end of tube or pipe
- Lead chamfer or point bar stock – 22-1/2° chamfer angle
- Round bar stock ends – use special tool bits
- Motor: ¾ HP
- Size – Manual operated – 26” x 22” x 17”
- Size – Air operated – 26” x 33” x 18”
- All electrical components in power panel are “finger-safe” and are in accordance with NFPA standards
- Machine is properly labeled with pinch and hazard points