Machines

660 End Finishing Machine

The Pines Model 660 End Finishing Machine enables even inexperienced operators to accurately finish up to 1875 ends an hour. This economical machine can cut costs by freeing lathes or other expensive machines on a wide range of work, such as simultaneous inside-outside deburring, chamfering, and facing. It can also increase production and improve accuracy over abrasive belts, deburring wheels, or other similar methods.

Pines Model 660 End Finishing Machine

View Video

Download Specs

Configuration

The Pines Model 660 End Finishing Machine is built to stock with the following standard equipment:

  • Capable of tubing range from 7/16” to 2” diameter
  • Manually lever operated
  • ¾ HP motor
  • Finish up to 1500 ends per hour
  • Power: 115V/1 phase /3 Hz

Many options are available to customize the machine. Including but not limited to:

  • Air operated – Increased production by 25% – 30%
  • Standard tool holder seats three bites for inside-outside deburring, chamfering and facing.
  • Special tool holder – no tool bits – covers work for 1/8” min OD through 5/8” max OD
  • Standard tool bits – fits standard tool heads. Size from 7/16” min to 2” max
  • Tool setting gauge
  • Vertical mounting base
  • Coolant unit
  • 1 HP Modification – Motor has 560 – 1250 RPM range

Capacities

  • Round tubing, 7/16” to 2” with standard tool holder
  • Round tubing, 1/16” to 5/8” with special tool holder

Specifications

  • Finish up to 1500 ends per hour
  • Deburr and chamfer inside, outside and face end of tube or pipe
  • Lead chamfer or point bar stock – 22-1/2° chamfer angle
  • Round bar stock ends – use special tool bits
  • Motor: ¾ HP
  • Size – Manual operated – 26” x 22” x 17”
  • Size – Air operated – 26” x 33” x 18”

Safety Features

  • All electrical components in power panel are “finger-safe” and are in accordance with NFPA standards
  • Machine is properly labeled with pinch and hazard points